Injection Molding Machines

Break & Breakthrough ... the Zero-molding Zero-molding aims to bring waste, defects and trouble vectors as close to zero as possible.


  1. 1MCM(Minimum Clamping Molding)

MCM uses means for detecting the minimum clamp force so as to enable molding at a low clamp force.

Because clamp force is not applied beyond what is necessary, the benefits are far-reaching : reduced defects caused by gas, longer mold maintenance cycles, less damage to mold parts and reduced power consumption.

The SE-EV Series incorporates a linear guide support for the moving platen, a highly rigid frame and a high precision nozzle touch feature. Together, they improve precision at low clamp force in the form of clamping accuracy, clamp force balance, planarity and surface pressure. As a result, molding is stable even at extremely low clamp force.

  1. 2FFC (Flow Front Control)

FFC optimizes flow control. This is made possible by ISC (Intelligent Servo Control) with a direct drive system at its core. Besides eliminating burrs and short shots, it markedly improves filling balance.

8 cavities coil bobbin

FFC evolved with the latest ISC II

The screw is accurately controlled by employing the latest advances in servo control to control low inertia, high response servomotors. Moreover, enhanced accuracy in injection pressure and weighing speed detection makes plasticization, filling and pressure holding processes more precise and stable. And, filling pressure is lower and more balanced.

  1. 3SPS (Simple Process Setting)

SPS gives top priority to operator operability, by adopting an operating system that allots a separate screen for each operation instead of setting up operations function by function as was done with earlier systems. Because a series of operations are set up on a single screen, operation is simple and free of errors and overlooked settings.

NC-10 Controller

For mistake-free operation

Operating keys are laid out to enhance operability when mounting molds and setting molding conditions, and to prevent accidents and mold damage caused by operational mistakes.

Intuitive touch-screen operation

Screens appearing on the 15.1-inch touch panel haveintuitive designs with multiple pictograms that make operation easy even for first-timers.

Product lines

For detailed information about the products please contact

Plastics Machinery Division

Products for inquiries
Injection Molding Machines, Transfer Molding Presses