SITE MAP JAPANESE FPW series illustration *Click a picture above for enlarging view.   Feature FPA series adopts rigid and strong against offset force. Press frame : The frame is consists of 3 major parts. These parts are fixed with strong tie-rods by heat-shrinkage. In this way, compressive stress is applied to the press frame. For minimizing horizontal displacement at columns, high strength horizontal frames are adopted. Slide : 2 points type of con-rod and a long guided slide made of cast steel are adopted for against a large offset load. Wear plate made of carbon steel is installed at surface of slide guide to prevent wear. Drive mechanism : Due to mechanism of suspended the flywheel at the main sleeve, load against the eccentric shaft and the main bush is reduced. Risk of heat generation is also prevented. Shut height adjustment : shut height adjustment is carried out by changing position of the eccentric wrist pin (Our Utility Model). The wrist pin is moved by hydraulic motor driven screw. The adjustment is able to be controlled at remote location. Amount of adjustment can be shown at digital counter located at the control panel. Clutch and brake : For improving maintainability, block type of lining is adopted for both clutch and brake. FPW Series Specifications 2points FPW-2000s FPW-2500s FPW-3000s Tons capacity (MN) {tf} 20 25 30 {2000} {2500} {3000} Stroke distance (mm) 400 400 400 Press speed (spm) 20∼40 20∼40 20∼40 Shut height (mm) 1200 1200 1300 Slide adjustment (mm) 8 8 8 Table dimensions R-L(mm) 1800 1800 1800 F-R(mm) 1500 1500 1600 Slide knock-out (kN×mm) 200×40 200×40 300×50 {tf×mm} {20×40} {20×40} {30×50} Bottom knock-out (kN×mm) 600×100 600×100 800×100 {tf×mm} {60×100} {60×100} {80×100} Main motor (kW) DC220 DC220 DC300 Number of tripping (tpm) 20∼40 20∼40 20∼40 Max.50 Max.45 TFPW-2500S TFPW-2000S Personal Information Protection PolicyTerms of Use Copyright(C)2009 Sumitomo Heavy Industries Techno-Fort Co.,Ltd. All rights reserved.