• Top
  • The list of printers compatible with the injection molding machine

The list of printers compatible with the injection molding machine

Our injection molding machines (SE-DU, SED, SES, SHC, iM, SGM, SHM, ULTRA, SHA, SG-M4, SD, SV) can be connected with the listed general printers.

1. Interface specifications

1-1) Data transmission method 8 bits parallel (IEEE-P1284-compliant) Centronics-compliant
1-2) Synchronization method External supply STROBE pulse signal
1-3) Handshake ACKNLG and the BUSY signal
1-4) Logic level Input data and the control signal are compatible with TTL level
1-5) Conformity connector The 57-30360 (Amphenol) 36-pin plug or an equivalent product

2. Control command

The printers must be operable with either one of the following printer control codes.

2-1) ESC/P24-J84 Usable at the printer setting “ESC/P**” of the molding machine
Screen output for all languages is possible
2-2) 201PL Usable at the printer setting “PC-PR**” of the molding machine
Screen output for all languages is possible
2-3) NM Usable at the printer setting “NM**” of the molding machine
Screen output for all languages is possible
2-4) ESC/P2 Usable at the printer setting “IBM**” of the molding machine
Screen output except Japanese/Chinese sentences is possible
(Supplements)
2-5) PCL3 Usable at the printer setting “HP**” of the molding machine
Screen output for all languages is possible
Usable for the series after SE-D series (N8 controller)

3. Usable papers

Cut papers larger than A4 (210*297mm) or continuous papers more than 10 inches wide.
For your convenience, we have summarized currently available printers in the attached paper.